Manual 4-Head Keg Filler

$2,350.00

5 in stock

A 4-Head Keg Filler Manifold to manually fill up to 4 Kegs at once.
All Keg Fillers have a Lead Time and are not kept In-Stock in the facility.
Contact us for more details about receiving your own Keg Filler!

  • 304 Sanitary Stainless Steel
  • (5) 1.5″ Butterfly Valves
  • (4) Keg Coupler (American Sanky D coupler) Filler with return line to the fermenter as a clear indication of a full KEG.
  • CO2 port
  • No air contact to ensure the quality of beer.
  • (1) Sight Glass
  • (1) Pressure Gauge
  • (1) Elbow Fitting
  • End Caps
  • Beer and CO2 Hose
  • Clamps, Gaskets

 

Process:

  • Make sure that your Kegs are properly cleaned, sanitized, and pressurized.
  • Connect sanitized fittings to the wracking arm. Open the racking arm valve as well as cracking open your BEER valve on the coupler to purge the sanitizer. Close the BEER valve and make sure that your GAS valve is closed.
  • Attach the coupler to your keg. Slowly open the GAS valve to vent CO2. Open BEER valve fully, filling the keg under counter pressure.
  • When foam begins to flow from the GAS tube, open GAS valve completely then immediately snap it closed. (This should result in beer rather than foam exiting the GAS valve.)
  • Wait for at least 10 seconds with the GAS valve closed and the BEER valve open. This should push a little more beer in, settling foam and stabilizing the pressure.
  • Close your BEER valve and remove the coupler from the keg.

If foam becomes an issue, you may be filling your kegs too quickly.

SKU: 4HEAD-KEG-FILLER-MANUAL Category: